Outside Corner (Female)

Has two 1/2" welded tabs. Use with a male outside corner. Each leg is 10"L x 5"H.

P/N 26521 - Standard Grade
P/N 26400- Commercial Grade

Outside Corner (Male)

Has one 1/2" welded tab. Use with a female outside corner to connect docks end to end. Joint requires 3/4" bolt set (N) or connector pin (O). Each leg is 10"L x 5" H.

P/N 26522- Standard Grade
P/N 25491- Commercial Grade

Outside Corner End

P/N 26523- Standard Grade
P/N 26402- Commercial Grade

Inside Corner

This heavy- duty inside corner should be used with one of the outside corners. Each leg has elongated holes for easy fit-up and is 8-1/2"L x 5"H.

P/N 26524 - Standard Grade
P/N 26403 - Commercial Grade

Inside Corner/Pipe holder 2"

These heavy-duty inside corners should be used with one of the outside corners and as an internal pipe holder to be used with either 2" pipe (P/N 26525) or give strength to the dockÕs frame. Measures 8-1/2"L x 5"H. Requires carriage bolt set (M) for attaching.

P/N 26526 - Standard Grade
P/N 26405 - Commercial Grade
Inside Corner/Pipe Holder 3"
P/N 26525 - Standard Grade
P/N 26404 - Commercial Grade

Angle

Use this heavy-duty angle for all cross supports. Each leg measures 2-1/2"L x 5"H.

P/N 26527 - Standard Grade
P/N 26406 - Commercial Grade

Female T Connector

Has two welded 1/2" tabs. Bolts to side of dock to attach fingers and ramps. 5"L x5"H.

P/N 26528 - Standard Grade
P/N 26407 - Commercial Grade